How much do you know about polyester panel?







Use of polyester fiber panel:
Polyester fiber panel can be used as ceiling ceiling, decorative wall panel, sound-absorbing wall panel and space sound absorber. It can be used for sound absorption and decorative panel. Polyester fiberboard is widely used in home furnishing, theaters, concert halls, exhibition halls, libraries, gymnasiums, lecture halls, multi-purpose halls, hotels, hospitals, shopping malls, schools, conference rooms, recording studios, KTV rooms, bars and other decoration or acoustics place.
Polyester fiber panel features:
1. Sound absorption: The irregular mesh-like dense pores of the polyester fiber panel have a good porous sound absorption function and a wide sound absorption spectrum.
2. Decorative: The surface of the polyester fiber panel is dense, the material is easy to dry and color, and it can be processed into a variety of exquisite color cases or three-dimensional patterns; the panel is easy to cut and spliced, and can be freely combined with patterns and shapes, which is very decorative. Improve the decorative taste.
3. Environmental protection: The formaldehyde emission and radioactivity index of polyester fiber panel are better than national standards as tested by national testing institutions.
4. Practicality: Polyester fiber panel has the advantages of sound absorption, heat preservation, environmental protection, and strong decoration, and meets the requirements of national standard fireproof B1 level, and can be safely used in dry interior decoration. The polyester fiber panel is easy to install and easy to maintain. The dust can be cleaned with a flick of a vacuum cleaner and a duster. The dirty areas can also be wiped with water and detergent.
Installation method of polyester fiber panel
(1) Pay attention to panel selection and panel arrangement before construction
Pay attention to the slight color difference, find the center point of the paste surface, draw a cross line, and use the method of laying bricks to arrange the panels from the center point.
(2) Cutting panel surface
Use a steel ruler and a sharp utility knife for corresponding cutting or trimming. If you want to reduce the seam, you can tilt the blade inward by 0.5~1mm when cutting, so that the edges of the panel can be docked and the gap can be reduced.
(3) Paste
1. Cement or wood base surface: benzene-free all-purpose glue or white latex with neoprene rubber as raw material can be selected.
2. The base surface of the paper-faced stone soundpanel; on the premise that it is not easy to be affected by moisture, white latex or cellulose-based wallpaper glue can be used (after brushing and pasting, it should be fixed with nails immediately to avoid the glue is not dry, the board face movement). Under the premise that it is easy or possible to get wet, all-purpose glue can be used.
3. Polyester fiber panel is a porous material, which is easy to absorb glue, block holes, and affect the sound-absorbing function of the rear cavity. It is recommended to apply glue on one side during construction (only apply glue on the base plate or keel, and the amount of glue applied is slightly heavier than normal). It can also be reinforced with studs.
